Pegboard Hooks - Supreme Fit. Will Not Fall Out!

Description

We are sorry for the changes but prices have gone up, but so have the volume discounts! Unfortunately if you order only one quantity, shipping takes up more then half the cost because eBay requires I use a service with tracking. Discounts of 15 percent now start at just orders of 2 quantities to take the edge off the price increase!
If you're like me, you have tried a mix of different hooks but they all wiggle and/or curve up too far and when you grab your tools the hooks come out with your tool and fall out! Not any more, these have a very snug fit into the pegboard because they are engineered to work in only one size of pegboard unlike the 100 pack of cheap thin plastic hooks or metal hooks that are designed to work with all pegboard. Buy nice or buy twice! Organize your workshop and get all those smaller items up and out of the way but still at your finger tips! These are our new design and they really lock into the pegboard and are very ridged.
Insertion and removal can be difficult without this one tip. The bottom peg has a bump that locks into the pegboard, to allow this bump to pass in or out of the pegboard easier,
simply lift upward while inserting or removing.
Also available now or soon in
our eBay store
in separate listings are mini shelf brackets, paper towel holder, and Dremel and hex bit holder!
Sheetmetal pegboard you ask? Check our other listings as these
do not work in Wall Control Pegboard
or other types of sheet metal pegboard.
Will they fit your pegboard?
These products are designed to work in
0.25 inch peg holes
and 1 inch spacing pegboard only. My pegboard measures 0.225 inches(So i consider it 1/4 inch thick, they do sell thinner pegboard so check before you order)
Y
ou should be able to fit a 1/4 inch drill though your pegboard holes, if you can't, then you have what is
referred
to as "small hole pegboard" and our products will not work.
These are our new design and they really lock into the pegboard with a tight, engineered fit. During install, you may encounter light resistance, this is normal and required to create a solid connection
.
Our max static loading recommendation is 5 lbs per hook. If you question the strength of printed items, I have set a 35lb brick on a only 2 of our 2.5 shelf brackets linked above using the same Peg hole capture design. The pegboard is the limitation when it comes to weight, during testing I was able to pull on our shelf bracket and the pegboard material gave way before our product did. Proceed with caution if you are going to exceed the weight limit recommendation of 5 lbs as I have not done formal testing above that weight yet.
Disclaimer-
We do not weight test each hook as it comes off the printer. We
are not liable for damage done to your pegboard or the products you hang on your hooks. If you do break one we would like to know the circumstance that it broke under and we can certainly replace it on a case by case basis.
For bulk orders greater then what is listed as available, contact me and we can discuss options. Ordering over 5
quantities
can take a day or more to process since we print these as they are ordered and we can be backlogged as well if a lot of orders come in at once. More printers are on order.
Custom colors are available upon request for large orders. Other special projects related to 3d printing will also be considered, just ask. There are various other pegboard products designed by others on Thingiverse you may want to ask us about as well.